Intel® Ethernet Controller I226 Windows NDIS Driver Release 2.1.4.3
Version: 2.1.4.3

Bug fixes:
-Low Performance TCP/UDP with 9KJumbo Packet enabled - 1Gbps
-With Switch TL-SG108-M2(2.5G) &TL-SG108E, Link sometime downgrade to lower speed after Disable enable the driver in Windows(EEEdisable)
-Win11Driver Installation Issue
-Intel I225& I226LAN lost when enabling Jumbo Packet in Intel Driver with 4*32GB RAM
-The system always hit BSOD "system thread exception not handled" after writing 0x0001in word 0x016 (MSI-X Configuration)in NVM
-Netadapter driversare indicating redundant linkup indication to the OS after RTD3
-Sporadic Networking Connection Dropson Certain Switches and Routers (Reference Sighting Alert RDC#768439)
-[NetAdapterCx]Speed & Duplex value can NOT be applied onI226/ I225
-[FXVL][NetAdapter] Driver sendsa bunch of error messages to event viewer when a surprise removal occurs
-[RPL-S][vPro] FXVLsends"Get LinkStatus" response message with an indication that the host is up when waking from CM3-PG -S5'
-Enabled Energy Efficient Ethernet (EEE)
-BSOD 0x9F occurred when Thunderbolt docking (full inserted)unplug then restart
-I225V TP-LINK TL-SG108-M2 SWITCH_ no Linkin SX_S3backto S0drop to 100Mbps
-Windows 11 22H2(SV2) WHQL
-Fixing DHCP response after S3and S4
-Enable EEE(Energy Efficient Ethernet) on I226
-Production Release for Intel® Ethernet Controller I226
-Fix INF Error for Windows11 WHQLcertification
-[RCR]Remove D3Cold reporting to align POR



Intel® Ethernet Controller I226 Windows NDIS Driver Release 1.1.4.42
Version: 1.1.4.42

Bug fixes:
- [Docking][I226]when plug/remove docking, I226 didn't disappear in DM, press refresh button found system hang.
- Fix for MsgDll not being properly referenced by INF
- [I226] BSOD observed after exiting from ULP in S0 state
- Gige camera acquisition in UDP experiencing frame corrupted
- Sporadic Networking Connection Drops on Certain Switches and Routers



Intel® Ethernet Controller I226 Windows NDIS Driver Release 
Version: 1.1.3.34

Bug fixes:
- I225V TP-LINK TL-SG108-M2 SWITCH_ no Link in SX_S3 back to S0 drop to 100Mbps
- Yellow Bang (Code 10) on I225LMvP in S0 hot attach
- Fail to RDP during CS (IPv4) after G3 with NDIS driver
- wakeupFiltersExt member is not cleared by the SW after D3
- Flow Control Receive Threshold High Value Calculation default value is incorrect